Water Purifying Plant

 

Major construction work was necessary on the 40 foot container as the outside had to meet ISO shipping regulations with no protrusions.

Massive holes had to be cut into both sides of the container and large side loading doors fitted. 

As we were to install several tons of equipment inside the container we also needed to strengthen the container to replace the integrity strength of the container.

The customer asked for a gantry crain to load heavy equipment. We turned the container onto its roof to strengthen and reinforce the ceiling area to take the weight that the crain would lift.

Once the container was turned the correct way up, the rest of the cutting and fabricating was able to continue.

Door ways, vents and the huge through side loading doors was able to be finished.

All the work was undertaken by Container conversions and completed 'In-house'

The electrical control gear and heavy pipe work fitted to the inside of the container

Once the water purifying plant was fitted it was fired up and tested. 

To the best of our knowledge, this container is still chugging away, producing fresh clean water somewhere in the desert!

 

 

 

 

 

 

 

 

This Page Is Copyright Of  Container Conversions
IF YOU ARE SEEING ONLY A SINGLE PAGE PLEASE CLICK HERE TO GO TO FULL WEB SITE